-- *****************************************************************
-- C I S C O A T M Traffic Parameter Extensions
--
-- December 1995, Michael Grobelch
--
-- Copyright (c) 1996-1997, 2001 by Cisco Systems, Inc.
-- All rights reserved.
-- *****************************************************************
--CISCO-ATM-TRAFFIC-MIB DEFINITIONS::=BEGINIMPORTSMODULE-IDENTITY,OBJECT-TYPE,OBJECT-IDENTITYFROM SNMPv2-SMI
atmTrafficDescrParamEntry FROM ATM-MIB -- RFC 1695ciscoExperiment FROM CISCO-SMI
MODULE-COMPLIANCE,OBJECT-GROUPFROM SNMPv2-CONF
SnmpAdminStringFROM SNMP-FRAMEWORK-MIB;ciscoAtmTrafficExtMIB MODULE-IDENTITYLAST-UPDATED"200208260000Z"ORGANIZATION"Cisco System Inc."CONTACT-INFO"Cisco Systems
Customer Service
Postal: 170 W. Tasman Drive
San Jose, CA 95134
USA
Tel: +1 800 553-NETS
E-mail: cs-atm@cisco.com"DESCRIPTION"This MIB module is an extension to traffic OIDs
and variables defined in rfc1695."REVISION"200208260000Z"DESCRIPTION"Deprecated atmNoClpNoScrCdvt as a similar object
atmNoClpNoScrCdvt defined in RFC-2514 can be used instead."REVISION"200111010000Z"DESCRIPTION"Added an object to identify the traffic descriptor by a
name in human readable form."REVISION"9705290000Z"DESCRIPTION"Added traffic for types dual-leaky bucket and mcr support
made possible on the LS1010 by the Feature Card Per Flow
Queueing support for per-VC queueing hardware structures."::={ ciscoExperiment 11}ciscoAtmTrafficExtMIBObjects OBJECTIDENTIFIER::={ ciscoAtmTrafficExtMIB 1}-- This MIB defines a two Groups:
--
-- 1. the ATM Traffic Type Extension Group, extending the
-- RFC 1695 mib Traffic Types.
-- 2. the ATM Traffic Descriptor Parameter Table Extension Group,
-- extending the RFC 1695 mib Traffic Table.ciscoAtmTrafficTypeExt OBJECTIDENTIFIER::={ ciscoAtmTrafficExtMIBObjects 1}ciscoAtmTrafficTableExt OBJECTIDENTIFIER::=
{ ciscoAtmTrafficExtMIBObjects 2}--
-- The ATM Traffic Type Extension Group
--atmNoClpNoScrCdvt OBJECT-IDENTITYSTATUSdeprecated-- superceded by atmNoClpNoScrCdvt-- OID in RFC 2514.DESCRIPTION"Specifies peak cell rate for CLP, and
cell delay variation tolerance:
Parameter 1: CLP=0+1 peak cell rate in
cells per second
Parameter 2: CDVT in cell-times
Parameter 3: not used
Parameter 4: not used
Parameter 5: not used.
This traffic descriptor is for cbr, abr
or ubr service categories, desiring to
specify the cdvt as well as pcr."::={ ciscoAtmTrafficTypeExt 1}atmClpScrMbsCdvt OBJECT-IDENTITYSTATUScurrentDESCRIPTION
"This traffic descriptor is for Peak
Cell Rate (PCR), Sustained Cell Rate (SCR),
Maximum Burst Size applied to SCR,
and Cell Delay Variation Tolerance
applied to PCR.
The use of the parameter vector for this type:
Parameter 1: CLP=0+1 peak cell rate in
cells per second
Parameter 2: CLP=0 sustained cell rate in
cells per second.
Parameter 3: maximum burst size in cells
Parameter 4: CDVT in cell-times
Parameter 5: not used."::={ ciscoAtmTrafficTypeExt 2}atmNoClpScrMbsCdvt OBJECT-IDENTITYSTATUScurrentDESCRIPTION"This traffic descriptor is for Peak
Cell Rate (PCR), Sustained Cell Rate (SCR),
Maximum Burst Size applied to SCR,
and Cell Delay Variation Tolerance
applied to PCR.
The use of the parameter vector for this type:
Parameter 1: CLP=0+1 peak cell rate in
cells per second
Parameter 2: CLP=0+1 sustained cell rate in
cells per second.
Parameter 3: maximum burst size in cells
Parameter 4: CDVT in cell-times
Parameter 5: not used."::={ ciscoAtmTrafficTypeExt 3}atmNoClpMcr OBJECT-IDENTITYSTATUScurrentDESCRIPTION"This traffic descriptor is for Peak
Cell Rate (PCR) and Minimum Cell Rate
(MCR).
The use of the parameter vector for this type:
Parameter 1: CLP=0+1 peak cell rate in
cells per second
Parameter 2: CLP=0+1 minimum cell rate in
cells per second.
Parameter 3: not used.
Parameter 4: not used.
Parameter 5: not used."::={ ciscoAtmTrafficTypeExt 4}atmNoClpMcrCdvt OBJECT-IDENTITYSTATUScurrentDESCRIPTION"This traffic descriptor is for Peak
Cell Rate (PCR), Minimum Cell Rate (MCR),
and Cell Delay Variation Tolerance
applied to PCR.
The use of the parameter vector for this type:
Parameter 1: CLP=0+1 peak cell rate in
cells per second
Parameter 2: CDVT in cell-times
Parameter 3: CLP=0+1 minimum cell rate in
cells per second.
Parameter 4: not used.
Parameter 5: not used."::={ ciscoAtmTrafficTypeExt 5}--
-- The ATM Traffic Descriptor Parameter Table Extension Group
--atmTrafficDescrParamExtTable OBJECT-TYPESYNTAXSEQUENCEOF AtmTrafficDescrParamExtEntry
MAX-ACCESSnot-accessibleSTATUScurrentDESCRIPTION"Provide additional information specifying traffic parameters
for a VC/VP."::={ ciscoAtmTrafficTableExt 1}atmTrafficDescrParamExtEntry OBJECT-TYPESYNTAX AtmTrafficDescrParamExtEntry
MAX-ACCESSnot-accessible
STATUScurrentDESCRIPTION" An entry in the Traffic Parameter Descriptor extension
table."AUGMENTS{ atmTrafficDescrParamEntry }::={ atmTrafficDescrParamExtTable 1}
AtmTrafficDescrParamExtEntry ::=SEQUENCE{
atmTrafficExplicitServCategory INTEGER,
atmTrafficDerivedServCategory INTEGER,
atmTrafficDescriptorName SnmpAdminString}atmTrafficExplicitServCategory OBJECT-TYPESYNTAXINTEGER{cbr (1),vbrRt (2),vbrNrt (3),
abr (4),ubr (5),notDef (6)}MAX-ACCESSread-createSTATUScurrentDESCRIPTION"This objects indicates the Service Category
specified by the Traffic Descriptor.
If it is defined, the setting of this
object determines the Service Category used
for the connection. This then limits the
possible Traffic Descriptor Types as follows:
Explicit
Service
Category Type may only be
-----------------------------------------
cbr atmNoClpNoScr.
atmClpNoTaggingNoScr
atmClpTaggingNoScr
atmNoClpNoScrCdvt
abr/ubr atmNoTrafficDescriptor
atmNoClpNoScr.
atmNoClpNoScrCdvt
atmNoClpMcr -- ubr+/abr
atmNoClpMcrCdvt -- ubr+/abr
vbr atmNoClpScr
atmClpNoTaggingScr
atmClpTaggingScr
atmClpScrMbsCdvt
atmNoClpScrMbsCdvt
-----------------------------------------
If the settings of Service Category and Traffic
Descriptor Type are not compatible, the row can
not be made active."DEFVAL{ notDef }::={ atmTrafficDescrParamExtEntry 1}atmTrafficDerivedServCategory OBJECT-TYPESYNTAXINTEGER{cbr (1),vbrRt (2),vbrNrt (3),abr (4),ubr (5)
}MAX-ACCESSread-onlySTATUScurrentDESCRIPTION"This object indicates the Service Category
derived from the Traffic Descriptor. If the
object atmTrafficExplicitServCategory has
a defined value, then this object mirrors
that value. If Explicit Service Category
has the value notDef, then this object
reflects the Service Category derived from
the Traffic Descriptor Type as follows:
Traffic Descriptor Service
Type Category
-----------------------------------------
atmNoTrafficDescriptor ubr
atmNoClpMcr abr
atmNoClpMcrCdvt abr
atmNoClpNoScr --|
atmClpNoTaggingNoScr |-- cbr
atmClpTaggingNoScr |
atmNoClpNoScrCdvt --|
atmNoClpScr --|
atmClpNoTaggingScr |-- vbr-rt
atmClpScrMbsCdvt |
atmNoClpScrMbsCdvt |
atmClpTaggingScr --|
-----------------------------------------"::={ atmTrafficDescrParamExtEntry 2}
atmTrafficDescriptorName OBJECT-TYPESYNTAXSnmpAdminStringMAX-ACCESSread-createSTATUScurrentDESCRIPTION"A human readable string that contains the unique name
of this Traffic Descriptor.
This object will return a zero-length string if value is
not set."DEFVAL{""}::={ atmTrafficDescrParamExtEntry 3}-- conformance informationciscoAtmTrafficExtMIBConformance
OBJECTIDENTIFIER::={ ciscoAtmTrafficExtMIB 3}ciscoAtmTrafficExtMIBCompliances
OBJECTIDENTIFIER::={ ciscoAtmTrafficExtMIBConformance 1}
ciscoAtmTrafficExtMIBGroups
OBJECTIDENTIFIER::={ ciscoAtmTrafficExtMIBConformance 2}-- compliance statementsciscoAtmTrafficExtMIBCompliance MODULE-COMPLIANCESTATUSdeprecatedDESCRIPTION"The compliance statement for the Cisco ATM Traffic Extension MIB."MODULE-- this moduleMANDATORY-GROUPS{ ciscoAtmTrafficTableExtMIBGroup }::={ ciscoAtmTrafficExtMIBCompliances 1}ciscoAtmTrafficExtMIBComplianceRev1 MODULE-COMPLIANCESTATUScurrentDESCRIPTION"The compliance statement for the Cisco ATM Traffic Extension MIB."
MODULE-- this moduleMANDATORY-GROUPS{ ciscoAtmTrafficTableExtMIBGroup }GROUP ciscoAtmTrafficNmsGroup
DESCRIPTION"This group is optional."::={ ciscoAtmTrafficExtMIBCompliances 2}-- units of conformanceciscoAtmTrafficTableExtMIBGroup OBJECT-GROUPOBJECTS{
atmTrafficExplicitServCategory,
atmTrafficDerivedServCategory
}STATUScurrentDESCRIPTION"A collection of objects which provide extensions to the
ATM Traffic Parameter Descriptor Table."::={ ciscoAtmTrafficExtMIBGroups 1}ciscoAtmTrafficNmsGroup OBJECT-GROUPOBJECTS{
atmTrafficDescriptorName
}STATUScurrentDESCRIPTION"A collection of objects which provide additional
information for a management system."::={ ciscoAtmTrafficExtMIBGroups 2}END